Eaton XV300 Series - Mounting Methods

3. Installation
3.3 Mounting
3.3 Mounting
NOTICE
Arrange for a professional technician to mount the device.
CAUTION
INSTALLATIONCUT-OUT
Themountingcutoutmustbelocatedinapositionthatwillnotdefeatthe
purposeofstabilizingwebsorotherreinforcingelementsinthecontrol
panel.Ifnecessary,reinforcingelementsmustbeinstalled/added.
AnIP65,Nema4xorNema12degreeofprotectionwillonlybeensuredif
thereissufficientstiffness,thedeviceisproperlymountedusingtheoriginal
fixingmaterial,andthegaskethasaproperseat
l Minimum sheet thickness of control panel panel where the device will be flush
mounted:
2 mm (0.08") ≦ d ≦ 5 mm (0.2")
3.3.1 Fixing and sealing
Make sure to check that the "Mounting", page 36 are being met.
Make sure that the mounting cutout has the right size.
Check the Polyurethane foam gasket for damage and make sure it is resting cor-
rectly inside the enclosure groove.
Missing parts or damage
If you notice anything wrong, please contact your distributor or
Eaton Service +49 (0) 180 5 223822 (de,en)
36
XV30012/15 MN048017 ENwww.eaton.eu