•
•
•
The screen contains the following parameters:
Login Description Input Default
User name
Password
The user name and the associated password must be
enteredpreviouslytologintothesystemcentre.
See chapter Menu -6 8.7- Users for details about the user
management.
The following users are created at the factory:
Standard
User name: Service
Password: 0000
Equivalent in CI 3x00: Menu 9-3 and "Enter"
Extended rights e.g. for configuration of a UA
410 E controller or for performing a firmware
update
Username:Master
Password:0000
Equivalent in CI 3x00: Menu 9-3 and input date
backwards
Administrative rights e.g. for restore of the
factory settings
Username:Admin
Password:0000
Equivalent in CI 3x00: not available
See
description
-
Reset now? Text
"Resetting the password is only possible by resetting to
factory settings. Reset now?
The device can be reset to factory settings if the password
has been forgotten!
After the reset, the device can be reconfigured using the
user names and passwords mentioned above.
-
ATTENTION
Safety Note!Forsecurityreasons,all
passwords set at the factory should be changed
immediately after installation and
commissioning!
ATTENTION
Risk of loss of data and the configuration!
When resetting to factory settings, all archives
(operating and energy data), the alarm and
message list, all stored data and configurations
of the system centre are irretrievably deleted!
If the display is not touched for a period of 15 minutes, open entry screens are closed automatically
and the main menu of the system centre is displayed again. Any running entry by a user is cancelled
and inputs already made are discarded.
To Next Page
Loading...
Need help?
General
