•
•
•
•
•
•
•
•
•
•
Menu 4-1-7 - Alarm Signalling
The list element for configuration of the alarm signalling of the system centre is called using this
button. The required parameter is called and can be configured by tapping on a line or the associated symbol
for editing. Paging is performed using the up/down buttons or swiping to display more entries than those that
are currently visible.
The list element is structured as follows:
Pushover service*
Pushover alarms*
E-Mail (SMTP) service*
E-Mail (SMTP) Alarms*
Easy alarm destinations: 3 permanent configurable alarm destinations (LDSWin, LDSWin and SMS Anny
Way).
For these alarm destinations, the configured time ranges and special days are also displayed (read-only!).
Time ranges of the system centre
Specification of the special days
Provider for SMS destinations
Other: definition of the mode of operation of the multi-function relay AUX / tripping a test alarm
Extended alarm destinations 4..15
Pushover service
Pushover service Input Default
Application token Input of the application token from the
"Pushover Account"
max. 40 characters --
User code Input of the user code from the "Pushover
Account"
max. 40 characters --
Pushover alarms
Pushover alarms Input Default
Pushover activated The check mark must be set for activation of the
transmission of alarms via Pushover
-
Selection of the priorities The alarm priorities for which transmission of alarms via
Pushover should be performed can be selected in the
priority matrix.
The alarm priorities for the entire decade can be
selected by tapping on a priority in the column or row
header
-
*: These alarm signalling paths can only be configured on the screens of the system centre. Changes
can only be made by authorised personnel and are only possible when logged in as "Admin".
To Next Page
Loading...
Need help?
General
