ECKELMANN Virtus 5 Series - 12.2.2 Control panel cut-out



Firmware V7.16.x
16.05.2023
179/183
12.2.2 Control panel cut-out
Variant A: Technically most attractive solution with somewhat complex manufacture of the panel cut-out and
the 4 x 4 mm holes
Variant B: The rectangular panel cut-out can be realised quickly with a jigsaw, e.g. during commissioning /
service; however a mounting frame is needed for installation; see chapter Einbaurahmen zur
Schalttafelmontage.