7 Servicing and maintenance
NOTICE!
Material damage by using incorrect tools!
Material damage may arise by using incorrect tools. Use the correct tools.
DANGER!
If you believe that the unit can no longer be operated safely
, you must
decommission it immediately and secure it so that it cannot be used
inadvertently.
This applies:
–
if the unit shows visible signs of damage,
– if the unit no longer appears to be operational,
– after prolonged periods of storage under unfavourable conditions.
The following instructions must always be observed:
–
Prior to carrying out any work on electric parts, switch off the power supply
and secure the system against being switched back on again.
– Safety regulations and prescribed protective clothing when handling
chemicals should be followed.
– Attention must be paid to the information included on the product data
sheet of the metering medium used.
– The unit must only be operated with the supply and control voltage
specified in the Technical Data section.
CAUTION!
Changes or modifications are not permitted without prior
, written permission
from Ecolab Engineering GmbH and result in the forfeiting of any and all
warranty entitlements. Original spare parts and accessories approved by the
manufacturer heighten the degree of safety.
The use of other parts results in an exclusion of the warranty for any ensuing
consequences.
Please consider that the CE conformity expires in case of subsequent
conversions
Servicing and maintenance
36MAN054128 Ver. 01-06.2024
To Next Page
Loading...
