11 Decommissioning, removal and disposal
NOTICE!
The following disassembly description is the recommended method.
However
, different local conditions and physical factors will determine the most
appropriate method for disassembly in practice.
CAUTION!
When working on parts that come into contact with dangerous products,
the prescribed protective clothing (safety goggles, protective gloves, apron if
necessary) must be used because of the risk of burns.
When working on the electrical connection of a dispenser unit (e.g. EcoPlus
PDRX) all applicable international, national and local safety regulations must
be observed.
For work on the power connection, isolate it first (i.e. shut down power).
Recommended procedure
1. Disconnect power to the unit (if necessary).
2. Remove the detergent capsule.
3. Remove chemical residue from the funnel, e.g. by cleaning in a dishwasher
.
4. Close the hinged lid and operate the appliance with clean water for a few minutes.
5. Close the water inlet (using angle valve or similar) and remove the connection.
6. Disconnect the unit from its power source.
7. Drain the unit completely and clear all the chemical residue from inside the unit.
8. Either dispose of the unit in accordance with applicable national directives or
package safely (cardboard box with padding material) and return to the Ecolab-
authorised company for recycling.
Decommissioning, removal and disposal
53 MAN054128 Ver. 01-06.2024
To Next Page
Loading...
