Chapter 50
| IP Routing Commands
Border Gateway Protocol (BGPv4)
– 1150 –
Example
Console#show ip bgp scan
BGP scan is running
BGP scan interval is 60
Current BGP nexthop cache:
10.10.10.64 valid [IGP metric 0]
BGP connected route:
10.10.10.0/24
10.10.11.0/24
Console#
show ip bgp summary This command shows summary information for all connections.
Syntax
show ip bgp summary
Command Mode
Privileged Exec
Example
In the following example, “Up/Down” refers to the length of time the session has
been in the Established state, or the current status if not in Established state.
Console#show ip bgp summary
BGP router identifier 192.168.0.2, local AS number 100
RIB entries 0
Peers 1
Peer groups 0
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd
192.168.0.3 4 200 166 168 0 0 0 02:45:00 1
Total number of neighbors 1
Console#
show ip
community-list
This command shows routes permitted by a community list.
Syntax
show ip community-list [1-99 | 100-500 | community-list-name]
1-99 – Standard community list number that identifies one or more groups
of communities.
100-500 – Expanded community list number that identifies one or more
groups of communities.
community-list-name – Name of standard or expanded access list.
(Maximum length: 32 characters, no spaces or other special characters)
To Next Page
Loading...
Need help?
General