Chapter 51
| Multicast Routing Commands
PIM Multicast Routing
– 1196 –
ip pim
register-rate-limit
This command configures the rate at which register messages are sent by the
Designated Router (DR) for each (source, group) entry. Use the no form to restore
the default value.
Syntax
ip pim register-rate-limit rate
no ip pim register-rate-limit
rate - The maximum number of register packets per second. (Range: 1-
65535: Default: 0, which means no limit)
Default Setting
0
Command Mode
Global Configuration
Command Usage
This command can be used to relieve the load on the Designated Router (DR) and
RP. However, because register messages exceeding the limit are dropped, some
receivers may experience data packet loss within the first few seconds in which
register messages are sent from bursty sources.
Example
This example sets the register rate limit to 500 pps.
Console(config)#ip pim register-rate-limit 500
Console(config)#
ip pim register-source This command configures the IP source address of a register message to an address
other than the outgoing interface address of the designated router (DR) that leads
back toward the rendezvous point (RP). Use the no form to restore the default
setting.
Syntax
ip pim register-source interface vlan vlan-id
no ip pim register-source
vlan-id - VLAN ID (Range: 1-4094)
Default Setting
The IP address of the DR’s outgoing interface that leads back to the RP
Command Mode
Global Configuration
To Next Page
Loading...
Need help?
General