Chapter 4
| System Management Commands
File Management
– 146 –
This example shows how to copy a public-key used by SSH from an TFTP server.
Note that public key authentication via SSH is only supported for users configured
locally on the switch.
Console#copy tftp public-key
TFTP server IP address: 192.168.1.19
Choose public key type:
1. RSA: 2. DSA: <1-2>: 1
Source file name: steve.pub
Username: steve
TFTP Download
Success.
Write to FLASH Programming.
Success.
Console#
This example shows how to copy a file to an FTP server.
Console#copy ftp file
FTP server IP address: 169.254.1.11
User[anonymous]: admin
Password[]: *****
Choose file type:
1. config: 2. opcode: 2
Source file name: BLANC.BIX
Destination file name: BLANC.BIX
Console#
This example shows how to copy a file from an SFTP server. Note that the public key
offered by the server is not found on the local system, but is saved locally after the
user selects to continue the copy operation.
Console#copy sftp file
SFTP server IP address: 192.168.0.110
Choose file type:
1. config: 2. opcode: 1
Source file name: startup2.cfg
Destination file name: startup2.cfg
Login User Name: admin
Login User Password:
Press 'y' to allow connect to new sftp server,
and 'N' to deny connect to new sftp server: y
Success.
Console#
delete This command deletes a file or image.
Syntax
delete {file name
[unit:] filename | https-certificate | public-key username
[dsa | rsa]}
To Next Page
Loading...
Need help?
General