Chapter 4
| System Management Commands
Stacking
– 201 –
2 N
Console#
show switch stacking
button
This command shows the status of the stacking button.
Command Mode
Privileged Exec
Command Usage
Use the switch stacking button command to set the 10G ports to stacking mode.
Example
Console#show switch stacking button
Switch ID Config Status Active Status
--------- ------------- -------------
1 Y Y
Console#
show switch stacking
interfaces
This command shows if the stacking ports are up or down.
Command Mode
Privileged Exec
Command Usage
This command will not display any information unless the switch stacking button
command has been used to set the 10G ports to stacking mode.
Example
Console#show switch stacking interfaces brief
Interface Status
--------- ------
Eth 1/25 Down
Eth 1/26 Up
Eth 2/25 Up
Eth 2/26 Up
Eth 3/25 Up
Eth 3/26 Down
Console#show switch stacking interfaces ehternet 2/26
Interface Status
--------- ------
Eth 2/26 Up
Console#
To Next Page
Loading...
Need help?
General