Chapter 8
| Authentication Commands
RADIUS Client
– 253 –
radius-server
retransmit
This command sets the number of retries. Use the no form to restore the default.
Syntax
radius-server retransmit number-of-retries
no radius-server retransmit
number-of-retries - Number of times the switch will try to authenticate
logon access via the RADIUS server. (Range: 1 - 30)
Default Setting
2
Command Mode
Global Configuration
Example
Console(config)#radius-server retransmit 5
Console(config)#
radius-server timeout This command sets the interval between transmitting authentication requests to
the RADIUS server. Use the no form to restore the default.
Syntax
radius-server timeout number-of-seconds
no radius-server timeout
number-of-seconds - Number of seconds the switch waits for a reply before
resending a request. (Range: 1-65535)
Default Setting
5
Command Mode
Global Configuration
Example
Console(config)#radius-server timeout 10
Console(config)#
To Next Page
Loading...
Need help?
General