Chapter 9
| General Security Measures
Web Authentication
– 335 –
web-auth This command enables web authentication for an interface. Use the no form to
restore the default.
Syntax
[no] web-auth
Default Setting
Disabled
Command Mode
Interface Configuration
Command Usage
Both web-auth system-auth-control for the switch and web-auth for a port must
be enabled for the web authentication feature to be active.
Example
Console(config-if)#web-auth
Console(config-if)#
web-auth
re-authenticate (Port)
This command ends all web authentication sessions connected to the port and
forces the users to re-authenticate.
Syntax
web-auth re-authenticate interface interface
interface - Specifies a port interface.
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
Default Setting
None
Command Mode
Privileged Exec
Example
Console#web-auth re-authenticate interface ethernet 1/2
Console#
To Next Page
Loading...
Need help?
General