Chapter 24
| Multicast Filtering Commands
IGMP Snooping
– 682 –
ip igmp snooping vlan
query-resp-intvl
This command configures the maximum time the system waits for a response to
general queries. Use the no form to restore the default.
Syntax
ip igmp snooping vlan vlan-id query-resp-intvl interval
no ip igmp snooping vlan vlan-id query-resp-intvl
vlan-id - VLAN ID (Range: 1-4094)
interval - The maximum time the system waits for a response to general
queries. (Range: 10-31740 tenths of a second)
Default Setting
100 (10 seconds)
Command Mode
Global Configuration
Command Usage
This command applies when the switch is serving as the querier (page 669), or as a
proxy host when IGMP snooping proxy reporting is enabled (page 669).
Example
Console(config)#ip igmp snooping vlan 1 query-resp-intvl 20
Console(config)#
ip igmp snooping vlan
static
This command adds a port to a multicast group. Use the no form to remove the
port.
Syntax
[no] ip igmp snooping vlan vlan-id static ip-address interface
vlan-id - VLAN ID (Range: 1-4094)
ip-address - IP address for multicast group
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
Default Setting
None
To Next Page
Loading...
Need help?
General