Chapter 24
| Multicast Filtering Commands
MVR for IPv6
– 755 –
mvr6
robustness-value
This command configures the expected packet loss, and thereby the number of
times to generate report and group-specific queries. Use the no form to restore the
default setting.
Syntax
mvr6 robustness-value value
no mvr6 robustness-value
value - The robustness used for all interfaces. (Range: 1-10)
Default Setting
2
Command Mode
Global Configuration
Command Usage
â—† This command sets the number of times report messages are sent upstream
when changes are learned about downstream groups, and the number of times
group-specific queries are sent to downstream receiver ports.
â—† This command only takes effect when MVR6 proxy switching is enabled.
Example
Console(config)#mvr6 robustness-value 5
Console(config)#
Related Commands
mvr6 proxy-switching (753)
mvr6
source-port-mode
dynamic
This command configures the switch to only forward multicast streams which the
source port has dynamically joined. Use the no form to restore the default setting.
Syntax
[no] mvr6 source-port-mode dynamic
Default Setting
Forwards all multicast streams which have been specified in a profile and bound to
a domain.
Command Mode
Global Configuration
Command Usage
â—† By default, the switch forwards any multicast streams within the address range
set by a profile, and bound to a domain. The multicast streams are sent to all
To Next Page
Loading...
Need help?
General