Chapter 24
| Multicast Filtering Commands
MLD (Layer 3)
– 783 –
Example
The following shows how to configure the maximum response time to 20 seconds.
Console(config-if)#ipv6 mld max-resp-interval 200
Console(config-if)#
Related Commands
ipv6 mld query-interval (783)
ipv6 mld
query-interval
This command configures the frequency at which host query messages are sent.
Use the no form to restore the default.
Syntax
ipv6 mld query-interval seconds
no ipv6 mld query-interval
seconds - The frequency at which the switch sends MLD host-query
messages. (Range: 1-255 seconds)
Default Setting
125 seconds
Command Mode
Interface Configuration (VLAN)
Command Usage
â—† Multicast routers send host query messages to determine the interfaces that
are connected to downstream hosts requesting a specific multicast service.
Only the designated multicast router for a subnet sends host query messages,
which are addressed to the link-scope all-nodes multicast address FF02::1, and
uses a time-to-live (TTL) value of 1.
â—† The designated querier is the lowest IP-addressed multicast router on the
subnet.
Example
The following shows how to configure the query interval to 100 seconds.
Console(config-if)#ipv6 mld query-interval 100
Console(config-if)#
Related Commands
ipv6 mld max-resp-interval (782)
To Next Page
Loading...
Need help?
General