Chapter 50
| IP Routing Commands
Routing Information Protocol (RIP)
– 989 –
Default Setting
No neighbors are defined.
Command Mode
Router Configuration
Command Usage
â—† This command can be used to configure a static neighbor (specifically for point-
to-point links) with which this router will exchange routing information, rather
than relying on broadcast or multicast messages generated by the RIP protocol.
â—† Use this command in conjunction with the passive-interface command to
control the routing updates sent to specific neighbors.
Example
Console(config-router)#neighbor 10.2.0.254
Console(config-router)#
Related Commands
passive-interface (990)
network This command specifies the network interfaces that will be included in the RIP
routing process. Use the no form to remove an entry.
Syntax
[no] network {ip-address netmask | vlan vlan-id}
ip-address – IP address of a network directly connected to this router.
netmask - Network mask for the route. This mask identifies the network
address bits used for the associated routing entries.
vlan-id - VLAN ID. (Range: 1-4094)
Default Setting
No networks are specified.
Command Mode
Router Configuration
Command Usage
â—† RIP only sends and receives updates on interfaces specified by this command. If
a network is not specified, the interfaces in that network will not be advertised
in any RIP updates.
To Next Page
Loading...
Need help?
General