Edimax Print Server - Configuring NetWare 3.x as Remote Printer

25. Reset the print server to have the changes take
effect.
NOTE: If the print server you have is with
multiple printer connectors, you may create multiple
print queues and printer objects.
Your print server should now be ready to use. You
should be able to redirect printing to your print server
using a CAPTURE command such as the one shown in
the previous section.
5.2.2.2 Configuring as Remote Printer Mode
This remote printer feature is not available for
some print server models. Please see section 1.2. Make
sure that you have created the NetWare print server
with Type Remote using PCONSOLE utility before you
configure the print server. For more detailed
information about PCONSOLE, please refer to
NetWare’s manual. You can set up the NetWare print
server and print queue objects by following the steps
below:
1. Run the NetWare PCONSOLE program.
2. Change the current file server, if necessary, using the
Change Current File Server menu selection.
3. Choose the Print Queue Information menu selection.
4. Press the
Insert key to add a new print queue.
5. Type in a print queue name, such as “PQ” or “Q1”.