Edirol PC-80 - Using PC-80 as MIDI Controller - GM2 System On Message; Transmitting GM2 System On Message

75
Using the PC-80 as a MIDI controller keyboard
■ Transmitting a GM2 System On message
Here’s how to transmit a GM2 System On message .
fig.gm2-1_80
fig.util*
1
Simultaneously hold down the MIDI CH button and PGM CHANGE
button for a few moments.
The display will indicate “UTL ” and you will be in Utility mode.
fig.gm2
2
Press the keyboard key marked [GM2 SYS ON] .
The indication “GM2 ” starts blinking in the display.
fig.enter
3
Press the ENTER button.
* If you press a different button without pressing the ENTER button , the setting will be
cancelled.
The GM2 System On message has been sent.
213
PC-80_e.book 75 ページ ２００５年１１月１０日 木曜日 午前１１時３４分