Edwards ModuLaser User Manual

Chapter 2: Installation
ModuLaser Modular Aspirating Smoke Detector Installation Manual 29
Connecting to a fire alarm control panel
Note: Because of the many available options for connecting to a fire alarm
control panel, the following covers only the most common methods that are likely
to be used.
The detector provides the following options for interfacing with fire alarm control
panels:
• Inputs and outputs: This option allows (for example) connecting an output
on the module to an input on the fire panel to send event notifications to the
fire panel. The module output and control panel input require appropriate
configuration.
• Addressable Protocol Interface Cards (APICs): This option requires the
installation of an optional APIC board (not supplied). With the APIC board
installed and the addressable loop connected to the APIC connector on the
backplane PCB (display modules only), the detection system becomes an
additional device on the addressable loop.
See Appendix A “APIC installation” on page 91 for more information on installing
an APIC board.

Edwards ModuLaser Specifications

General

Brand	Edwards
Model	ModuLaser
Category	Smoke Alarm
Language	English