105Installation and Service Guide: Color Controller E-46A
Installing System Software
• Shut down the E-46A, wait one minute, and then power on the E-46A (see page 42).
• Reset the Fiery QuickTouch: press the reset button on side of the Fiery QuickTouch through the pinhole, and hold
the button down for two seconds (see Figure 44 on page 106).
After performing these methods, if the Fiery QuickTouch does not start up or not responding, proceed to install the
Fiery QuickTouch software.
To install the Fiery QuickTouch software
1 Make sure that the E-46A is in Idle status.
2 From the monitor connected to the E-46A, or from the Remote Desktop Connection session, locate the folder that
includes the system update image file by following the steps below:
a Browse “C:\Glance\image\NX-<version_number>-system_update” folder. The image file is located in this folder
if the Fiery QuickTouch software installation was incomplete, or if the image file is downloaded but not yet
installed.
b If you do not find the above folder, go to the “C:\Glance\image_backup” folder. Copy “NX-<version_number>-
system_update” folder and paste it in “C:\Glance\image”.
3 The E-46A detects the update file and starts the update process. Wait until the Fiery QuickTouch update process
completes and the E-46A reaches Idle state.
While updating the Fiery QuickTouch, the Fiery Ticker displays “Exited” on the status bar. Once the update is done
successfully, Fiery Ticker displays Idle on the status bar. The update process may take approximately 10 to 15
minutes to complete.
If the update process is not complete and the Fiery Ticker continues to display “Exited” on the status bar, proceed
with the step 4 to complete the update process manually.
To Next Page
Loading...
Need help?
General
