75Installation and Service Guide Color Controller E-46A
Replacing parts
CUIDADO: Existe peligro de explosión si la batería se sustituye por una batería del tipo incorrecto. Sustituya la batería
sólo por una batería del mismo tipo que recomienda el fabricante. Deseche las baterías usadas respetando la normativa
local.
ATTENZIONE: Esiste pericolo di esplosione se la batteria viene sostituita con una di tipo non corretto. Sostituirla
solamente con un tipo raccomandato dal produttore. Lo smaltimento delle batterie usate deve essere eseguito secondo
le normative locali.
AVISO: Existe o perigo de explosão se a bateria for substituída por uma do tipo incorreto. Substitua somente por uma
do tipo recomendado pelo fabricante. Descarte as baterias conforme as normas locais.
GEVAAR: Er bestaat ontploffingsgevaar indien de batterij door een verkeerd type wordt vervangen. Vervang de batterij
uitsluitend door hetzelfde door de fabrikant aanbevolen type. Ruim gebruikte batterijen op volgens de plaatselijke
voorschriften.
To replace the battery
1 Shut down, and then open the E-46A (see page 51).
2 Locate the battery on the motherboard (see Figure 33 on page 61).
3 Carefully push the clip away from the battery until the socket ejects the battery.
Figure 37: Motherboard battery
4 Slide the battery out of its socket.
5 Wait two minutes to allow the motherboard electrical components to fully discharge.
6 To insert a new battery, slide it into the socket so that the positive (+) side of the battery faces up.
7 Press the battery down into the socket until it snaps into place.
Make sure that the battery is securely installed in the socket.
8 Reassemble the system and verify its functionality (see page 86).
9 Configure the time and date (see page 76).
1 Clip
2 Battery
3Socket
Failure to configure the time and date will cause the E-46A to hang when user software is being
installed on the E-46A.
1
2
3
To Next Page
Loading...
Need help?
General
