131Installation and Service Guide: Color Controller E-46A
Servicing the E-46A with furniture
2 Open the back door of the NX Station and remove all the cables from the connector panel of the E-46A.
3 Pull the server tray of the NX Station out of the stand.
To replace the E-46A in the furniture
1 Make sure that all the chassis panels are attached.
2 Lift the E-46A and place it on the server tray.
3 Slide the tray into the stand.
4 Reconnect all the cables.
DANGER
To avoid injury, do not lift the E-46A without assistance.
To Next Page
Loading...
