14Installation and Service Guide: Color Controller E-46A
Introduction
The power cable
Observe the following guidelines:
• Only use the power cable that shipped with the E-46A or an appropriate replacement power cable. For replacement
parts, see your authorized service support center.
• Before you open the E-46A, unplug the E-46A.
• Keep the power cable away from foot traffic.
• Do not place objects on the power cable.
• Do not plug the E-46A into a 2-hole, ungrounded outlet by means of a 3-prong adapter.
• Do not plug the E-46A into a circuit connected to heating or refrigeration equipment (including a water dispenser).
• Do not plug the E-46A into a switchable outlet.
• Do not pull the cable to unplug the E-46A. Instead, pull the plug.
• Do not tamper with or disable the power cable grounding plug.
• Do not use an extension cord.
Do not have liquids near the E-46A
If liquid spills on the E-46A, immediately unplug the E-46A.
Do not open the power supply
For more information about the power supply, see“Power supply” on page 78.
Do not open the hard disk drive
For more information about the hard disk drive, see“Hard disk drive” on page 80.
Use caution with sharp edges
The edges of some E-46A components are sharp.
Power supply cord notice
Lithium battery notice
The power supply cord is used as the main disconnect device. Ensure that the power outlet is
located/installed near the equipment and is easily accessible.
DANGER
There is a danger of explosion if the battery is replaced with an incorrect type. Replace a battery
only with the same type recommended by the manufacturer. Dispose of used batteries according to
local regulations.
To Next Page
Loading...
Need help?
General
