24Installation and Service Guide: Color Controller E-46A
Installing Hardware
To enable the power synchronization feature at the E-46A
1 Make sure that the E-46A and the printer are powered off.
2 Make sure that the power synchronization switch on the E-46A connector panel is in the OFF position.
3 Remove the port cover that is attached to the Type B USB port on the E-46A connector panel.
4 Locate the USB power cable in the accessory kit that is shipped with the E-46A.
5 Connect one end of the USB power cable to the Type B USB port on the E-46A connector panel (see Figure 8).
6 Connect the other end of the USB power cable to the USB port on the printer.
To Next Page
Loading...
