ELAU PMC-2 - Status Information

Instruction Manual PMC-2
BA * PMC-2 * EN * 01/98 Page 11
2.5.3 Status information
/T1: standard operation
T1 set up, LOW-Power-operation active
Operating mode: parameter 1st initialisation
Error1 class 1 error
inactive no enable or class 2 error
-> active dc-circuit tension builds up
active PMC-2 in automatic control, but without operating mode
-> manual dc-circuit tension builds up and manual operation preselected
manual manual operation
-> auto dc-circuit tension builds up and automatic operation
preselected
auto automatic operation
Information: E_Off emergency stop active
Qstop quick stop active
stop start/stop on LOW (in operating mode Auto)
Sstep single step active
stops/moves: stops drive does not move
moves drive moves
ref/nref: ref drive is homed
nref drive is not homed
Diagnosis number: EXXX current diagnosis number