Instruction Manual PMC-2
BA * PMC-2 * EN * 01/98 Page 21
3.3 General safety instructions:
The following safety notes should be especially observed:
• The safety instructions are to be read and used by each person being occupied with the
commissioning, operation, maintenance and repair of the machine.
• In addition to the universally valid national and local regulations for prevention of accidents, pay
attention to the notes in this instruction manual.
• Before starting with any work on this equipment, switch the station currentless and secure it
against switch on.
• After installation, commissioning or repair of the electrical equipment and of the machine, test
the installed protection measures.
• Omit anything which will affect the safety of the machine.
• Unauthorised rebuildings or modifications on the equipment are prohibited due to safety reasons.
• Persons responsible for the safety of the station must guarantee that
− only qualified personnel will be entrusted with the work on the units and machines
− the instruction manual will be always available and that they are obliged to obey them.
− work on the equipment and on the machines is prohibited for unauthorised people.
• When working on the equipment, please observe the corresponding notes on the equipment
(e. g. front sides, case, etc.)
• The PMC-2 and the SB-XXX servo motor may only by used for the installations intended in this
manual and only in connection with external units and components recommended and authorised
by ELAU.
• The flawless and safe function of the product presupposes appropriate transport, storage,
arrangement and installation as well as careful service and maintenance.
To Next Page
Loading...