ELAU PMC-2 - Communication; Operation with Be-7

PMC-2 Instruction Manual
Page 8 BA * PMC-2 * EN * 01/98
2.4 Communication
The PMC-2 positioning motor controller communicates:
- with a PLC via inputs/outputs,
- with a PLC via serial data transfer,
- with operational and display units via serial data transfer
- with the Industrial I/O-Lightbus over option module
- with the INTERBUS-S (Remote bus) over option module
- with the PROFIBUS-DP
2.5 Operation with BE-7
MENU EMENU E ENTERENTER
M A X. . D R E H Z A H L
P5 0 2 3 0 00
ER ROR
QUIT
ER ROR
QUIT
CECE
The PMC-2 can optionally be equipped with the BE-7 operational unit. Only dock the BE-7 via a d-sub
connector. You need the BE-7 for commissioning if you do not a have a PC with EPAS-3 or in
diagnosis cases. German, English, French, Italian and Spanish texts facilitate the dialogue with the
PMC-2.
Access protection
The conception of the PMC-2 includes an access protection mechanism. Parameters and variables
are divided in several access authorisation levels for writing and reading.
Performance features of the BE-7:
- parameter editor
parameters
direct parameters
- variable editor
inputs
outputs
flags
user variables
system variables