ELAU PMC-2 - Parameter Group 7 - Communication; Direct Parameter Variables (Y)

Instruction Manual PMC-2
BA * PMC-2 * EN * 01/98 Page 61
7.2.8 Parameter group 7 - communication
Number
P
Designation Unit Data
type
Access
level
Min-Max Default
7.00 KOM_Mode BS Foreman 00000000
7.01 Start_Timeout I32 Foreman 0 - 999999 10000
7.02 BUS_Timeout I32 Foreman 0 - 999999 100
7.03 KOM_Timeout I32 Foreman 0 - 999999 100
7.04 KOM_Address I32 Foreman 0 - 999999 1
7.3 Direct parameter variables (Y)
Direct parameters are variables which, in contrast to normal parameters, are immediately taken over.
Their purpose is to effect parameter changes in the ECL program. Direct parameters are initialised by
corresponding parameters (after power on or after the transfer of new parameters -> enable LOW).
When inscribing them, they are also limited to the parameter value.
Number
Y
Designation Unit Data
type
Access
level
Min-Max Default
00 max_current mA I32 Foreman 1-999999 P4.02
01 maximum_rpm Rev/min I32 Foreman 1-8000 P4.03
02 kv I32 Foreman 1-100 P1.00
02 language AT Foreman Ger/Engl./free P0.20
04 direction AT Foreman neg / pos P4.01
05 v_gain % I32 Foreman 0-200 P4.10
06 v_feed_forward % I32 Foreman 0-100 P4-02