ENG
WARNING
THIS PART OF THE MANUAL CONSISTS OF: Part 1 – Information, instructions and general warnings for the Transmitting Unit and
its charging system. The manual consists of Part 1 "Transmitting Unit user manual", Part 2 "Receiving Unit user manual", Position
of the controls and the Connection diagram.
THIS MANUAL, INCLUDING ALL ITS PARTS, AND ALL THE INSTRUCTIONS CONTAINED IN IT MUST BE READ CAREFULLY AND
UNDERSTOOD BEFORE EACH INSTALLATION, USE, MAINTENANCE OR REPARATION OPERATION OF THE ELCA RADIO REMOTE CONTROL.
FAILURE TO READ THE MANUAL AND COMPLY WITH ALL THE APPLICABLE WARNINGS AND INSTRUCTIONS, OR ANY RESTRICTION
PROVIDED IN THIS MANUAL CAN CAUSE SERIOUS PHYSICAL INJURIES OR DEATH AND/OR DAMAGE TO PROPERTY.
THE ELCA RADIO REMOTE CONTROL IS NOT AN INDEPENDENT PRODUCT AND IS EXCLUSIVELY A COMPONENT OF A MACHINE THAT:
- PERMITS A RADIO REMOTE CONTROL TO BE USED IN AN APPROPRIATE MANNER,
- CAN BE OPERATED SAFELY AND IN COMPLIANCE WITH ALL LEGAL PROVISIONS, REGULATIONS AND STANDARDS APPLICABLE
TO THIS RADIO REMOTE CONTROL.
ACCORDINGLY, IT IS THE RESPONSIBILITY OF THE MANUFACTURER AND THE DESIGNERS OF THE MACHINE ON WHICH YOU INTEND
TO INSTALL THE ELCA RADIO REMOTE CONTROL to carry out a careful and in-depth risk assessment to determine whether the Elca
radio remote control is suitable for the safe and efcient use of the Machine, taking into account the conditions of use and the
intended uses, and that the installation, maintenance and use of the Elca radio remote control and all its components are carried
out only and entirely in accordance with this Manual and in compliance with all local safety rules, standards and regulations
(referred to herein as "Laws, Regulations and Standards").
With reference to the US market, the Laws, regulations and Standards include all regulations and standards of the Occupational
Safety & Health Administration (OSHA) (http://www.osha.gov), all federal, state and local laws and provisions, the construction
and electric devices codes and all applicable standards, including, bit not only, ANSI standards.
To Next Page
Loading...
