28
04 DOORS & WINDOWS
DOOR ACTUATOR COVER
The door actuator cover is located
above the passenger entry door. This
cover protects the door linkage, actua-
tor, and door motor, (on electric doors
only). To access the door mechanism,
use a Phillips screw driver to remove
the securement fasteners. Then the
cover can be removed to access the
door mechanism. Simply reverse the
removal steps to re-install the cover.
Keep the door actuator cover installed at all
times, (except when repairs are being made), for
safety and to protect the door mechanism.
DOOR SEALS
u
Inspect door seals every week for
material quality and tight door closure.
u
Repair or replace damaged seals, as
necessary.
u
Spray door seal surfaces with a light
coating of silicone every 12,000 miles
or 3 months to keep the seals supple.
If door seals do not close tightly and they
do not show excessive wear, adjust the closing
mechanism according to the diagrams included
with the bus door, (information following in this
section).
Avoid over-lubrication as excess oil or grease
tend to collect dirt and may soil clothing.
DOOR ALIGNMENT
u
Check door alignment every week.
Over time, worn door pins and loose
fasteners may allow door hinges to
shift.
u
Tighten loose nuts, replace worn
parts, and/or realign doors as
necessary.
Image: Door Actuator Cover Installed
Illustration: Door Actuator Unit - Ortho Views
Image: Door Hinge And Seals
Image: Door Actuator Cover Removed
To Next Page
Loading...