79
vehicle, and make sure the ajar/locked
buzzer and light works, if equipped.
Inspect all seals, looking for tears,
accumulation of debris, and proper
contact with sealing surfaces. Check
that the prop operates smoothly and
holds the door in its full open position.
Inspect the entry door, checking that
it moves smoothly through its full
range of motion. Inspect all seals,
again looking for tears, accumulation
of debris, and proper contact with
sealing surfaces. Check the door for
proper operation in both powered
(if equipped) and manual modes of
operation. Ensure that all related
lighting activates when the door
is opened. Operate all additional
emergency exits and make sure their
buzzers and indicators work.
FINAL WALK-AROUND
1. With the parking brake applied, check
service and emergency exits. They
should all open, close, seal and secure
properly.
2. Inspect seats and floor for debris or
damage.
3. Verify that all interior and exterior
lights are functional.
4. Inspect the engine compartment for
fluid leaks while the engine is running.
5. Verify that all windows, access
panels and emergency equipment are
in place and in proper working order.
6. Inspect the underside of the bus and
make sure it is clear of obstructions.
Always check the rear of the vehicle if
backing up is required.
7. Check the wheelchair lift for
function. Report any problems to
service personnel.
13 MAINTENANCE CHECKLISTS
To Next Page
Loading...