6 TC3
6.1 General characteristics
The EWM09312 / EWX13611 / EWX14931 electronic control system consists of two circuit boards plus the
motor control (Inverter) for washing machines.
The TC3 styling has a single ON/OFF button, all the other choices/adjustments are made by skimming your
finger over the touch sensors, which replace the buttons used so far.
In the event of problems with the touch sensors (difficulty selecting/adjusting them), clean and dry the display
and do not wear gloves when setting the chosen programme.
The control/display circuit board, inserted in a plastic box, secured to the control panel (the figure illustrates:
the display circuit board with the side support plate onto which the selector is secured, connected to one
another by a flat cable and the display circuit board assembly).
Main board, positioned in the bottom rear of the appliance. It powers the electrical components and
receives commands from the display board as well as for EWX14931 communicating with the motor
control board (Inverter UIMC).
Maximum 9 (8 options + 1 start/pause)
14 positions (incorporated in the circuit board)
DAAS-EAP communication protocol up to 115,200 baud
Power supply voltage
220/240 V
50/60 Hz (configurable)
Traditional with “Eco-ball”
Traditional with “Eco-ball”
Collector, with tachometric generator (universal)
1 solenoid valve with 1 inlet – 2 outlets
3 compartments: pre-wash, wash and conditioners.
Control of water level in the tub
Electronic/analogue pressure switch
Heating element heat output
1,950 W with thermal fuses incorporated
NTC probe incorporated in the heating element
Traditional incorporated in the PCB
Inverter UIMC Main board EWX13611 / EWX14931 Main board EWM09312
Technical Support - DMM 22/124 599 75 58-67 Rev.04