Electrolux EWX13611 - Alarms, Troubleshooting, and Technical Characteristics; Alarm Display, Reading, and Error Codes

10 ALARMS
10.1 Displaying the alarms to the user
10.1.1 Styling TC5
The alarms are displayed by the flashing red LED of the START/PAUSE sensor and by one of the three LEDs
in the lower right hand corner of the display.
As soon as a problem arises these LEDs start flashing (half a second on and half a second off), until the
problem is resolved.
The table below illustrates the combinations of LED lightings.
E10
E20
E40
Water fill
difficulty
(tap closed)
Drain
difficulty
(filter fouled)
Door open
10.1.2 TC4/TC3 Styling
When a problem arises with the appliance, “WARNING” appears on the LCD screen, represented by a code
(three digits, indicating the time required for the cycle to end). At the same time the buzzer gives off three short
“beeps” every 20” for a period of 5 minutes.
Once the fault has been repaired the buzzer does not give off any “beeps” and the selected programme
appears on the LCD screen.
This does not occur for alarm EH0.
TC 4
TC 3
The alarms displayed to the user are listed below and can also be eliminated by the user:
TC4/TC3
E10 – Water fill difficulty (tap closed)
E20 – Drain difficulty (filter dirty)
E40 – Door open
EF0 – Excessive detergent
The alarm listed below:
TC5/TC4/TC3
EF0 – Water leakage (Aqua Control System)
The intervention of a service engineer is required.
For the alarm on the other hand:
TC5/TC4/TC3
EH0 – Voltage or frequency outside normal values
It is necessary to wait for power supply voltage and/or frequency to restore normal conditions.
Technical Support - DMM 38/124 599 75 58-67 Rev.04