7.2 Description of options
• Rinse hold
→ Stops the appliance with water in the tub before the final spin cycle.
→ To drain the water, reset the programme and then select a drain or spin cycle.
• Pre-wash
→ Adds a pre-wash phase at the start of the cycle with water heating to 30°C (or cold, if selected).
→ Available in COTTON cycles, performs a short spin before advancing to the wash phase.
• EXTRA-rinse
→ Add two rinses to the cycles where featured.
→ Eliminates the spin at the end of washing.
ENABLING/DISABLING EXTRA RINSE USING A COMBINATION OF SENSORS
Appliances which do not envisage the SUPER RINSE option combined with a button can enable it through
a sensor combination.
During the selecting phase, touch the two sensors shown in the figure simultaneously for a few seconds until
the related icon lights up. This option also remains enabled during subsequent cycles. To disable it, repeat the
same operation until the related icon is turned off.
• No spin
→ It eliminates all the spin phases.
→ It adds three rinses to the COTTON cycle and one to the SYNTHETIC FABRICS cycle.
• TM5-6-7-8
→ Modifies the structure of the COTTON - SYNTHETIC FABRICS - DELICATES cycles to obtain good
washing performance in a variable amount of time.
• TM2-3-4
→ Modifies the structure of the wash phase of the COTTON - SYNTHETIC FABRICS - DELICATES cycles
by half a load.
• TM1
→ Modifies the structure of the wash phase of the COTTONS - SYNTHETICS - DELICATES cycles by 1 kg
of laundry.
• Delayed start time
→ Adds a pause before the start of the programme. The delay time is displayed on the three digits
→ During the programme selection phase, a delayed start can be selected, from 30' to 20 hours (30'
60'
90' 2h 3h… 20h 0h) and the time is shown on the display; during the last one, the time
decreases one minute at a time.
→ To start the cycle immediately after the countdown to the delayed start has already begun:
press the Start/Pause button, cancel the delay time by pressing the relevant button, then press Start/Pause
again.
• Easy-iron
→ In COTTON programmes:
- adds three rinse cycles
- eliminates intermediate spin cycles
- performs a pulse spin phase before the final spin
- adds an “untangling” phase after the spin cycle
→ In SYNTHETIC FABRICS programmes:
- it reduces the heating temperature in 50/60°C cycles to 40°C
- increases the wash time
- prolongs the cooling phase at the end of the wash phase
- adds one rinse cycle
- adds an “untangling” phase after the pulse spin cycle
Technical Support - DMM
32/124 599 75 58-67 Rev.04
To Next Page
Loading...
