Electrolux LAUNDRY - Motor Access and Removal; Heating Element Access; Circulation Pump Access; Water Control Sensor Access

SOI/DT 2006-01 dmm 65/71 599 37 47-13
6.3.3 Motor
a. Detach the wiring connectors.
b. Remove the rear screws which secure the motor and loosen the front
screws.
c. Loosen the motor from the supports.
d. Remove the front screws and remove the motor.
6.3.4 Heating element
e. Detach the drive belt from the pulleys.
f. Detach the wiring connectors.
g. Remove the screw which secures the heating element flange.
h. Push the nut on the heating element flange towards the
interior of the tub.
i. Remove the heating element.
j. While inserting the new heating element, pay attention to fit it
correctly.
6.3.5 Circulation pump (if featured)
k. Detach the connectors.
l. Detach the hoses.
m. Remove the screw which secures the pump to the lower crosspiece
and extract it.
n. Pay attention while reassembling the pump that the rubbers are
placed correctly.
6.3.6 Water control (if featured)
o. Remove the rear panel.
p. Insert a screwdriver where indicated by the arrows.
q. Remove it.
r. Detach the connectors and replace it.
b
c
g
h i j
m