43. Cabinet
Service
manual
487 03 29 41
10
43
Righting the dryer (continued)
3. Fig. 3 Position the lifting tackle.
It is important to position the lifting
tackle below the back bearer C
so the centre of the lifting tackle
supports the bearer.
Before starting to lift the dryer ensure
that the support under the lifting
tackle is stable.
4. Fig. 4 Start lifting the dryer a little
bit so the bolt D is released in the
slot.
5. Remove bolts in both actuators.
6. Turn the actuators loose of the
fittings.
7. Carefully lower the dryer in upright
position.
8. Remove the lifting tackle.
9. Mount the connecting piece at the
outlet pipe.
10. Mount the back plates which
were dismounted back in step 1.
11. Connect the outlet pipe to the
system.
Note! When replacing an actuator,
both actuators must always be
replaced as a set.
4
D
3
C
To Next Page
Loading...
