MP500/4N-8-16 Installation
10. If the test result of any device is “INSUFFICIENT”, it is necessary to move these devices to a more favourable position in relation to
the control panel press OK and repeat the test from point 5.
Note: When it is not possible to obtain an acceptable signal level by only moving the devices (the excessive fading of the signal,
radio dead zones, ...), it is necessary to identify a different site for the radio expansion.
Once the radio expansion has been moved, press the OK key and repeat the test from point 5.
11. In case of doubt on the functioning of a device, position it temporarily near the control panel (about one metre) and repeat the test.
If the result for the device in question is “EXCELLENT”, it is functioning correctly; otherwise, it could be broken or lacking power.
12. Exit the menu by pressing the ESC key more than once.
7.7 CONFIGURING RADIO PARAMETERS
To modify the default configuration of the radio parameters of a single radio expansion:
Enter the menu: Maintenance → Radio devices → Configuration → Radio expansion Selection
Modify the Supervision/Jamming configuration according to one's needs.
The radio expansion does not control the presence or absence of radio devices belonging to it.
The radio expansion controls the presence of radio devices belonging to it, considering the absence of
communication as the pre-selected time interval.
The radio expansion does not control the occupation of the radio band by devices foreign to the system.
The radio expansion does control the occupation of the radio band by devices foreign to the system.
7.8 DELETING A RADIO DEVICE
To delete a radio associated with a radio expansion, follow the instructions below:
1. Use the arrows to enter the «Maintenance» → «Radio devices» → «Delete» menu; confirm each selection by pressing OK.
2. Select the radio expansion to be deleted.
3. Continue with the function keys and select the type of device to be deleted.
4. Select the device to be deleted. « Select IR 01» o « Select IR 02», etc.
5. For greater security, before deleting the device, the system requests further confirmation by visualizing the message: «Are you
sure?»; press the OK key to start the deletion.
6. The message «Deletion in progress…» will appear on the display.
7. Once the device has been deleted, the system will return to the menu at point 2.
To delete other radio devices, repeat the process by following points 2 to 5.
8. Once the deletion of radio devices is complete, press the ESC key on the keypad to exit the menu.
To Next Page