Elmo Bassoon - Main Feedback Cable (Port J3)

3.5.5 Main Feedback Cable (Port J3)
The main feedback cable is used to transfer feedback data from the motor to the drive.
The Bassoon accepts the following as a main feedback mechanism:
 Incremental encoder only
 Incremental encoder with digital Hall sensors
 Digital Hall sensors only
 Incremental Analog (Sine/Cosine) encoder (option)
 Resolver (option)
 Tachometer and potentiometer
 Absolute encoder
Connect the main feedback cable from the motor to the J3 port on the front of the Bassoon, using
a 12-pin, Molex plug.
 Connect the drain wire to pin 4. If the cable has no drain wire, connect the shield to
pin 4.
 Ground the shield to the motor chassis.
Figure
3-9: The Main Feedback (J3) Cable
Drain
Wire
Bassoon Installation Guide Installation
MAN-BASIG (Ver 1.4)
3-13