Elmo L-12F - Selecting the Image Source; Pausing the Image

19
BASIC
OPERATIONS

Selecting the image source
You can select the image source as
described below.
Camera image：
[ ] button on the operating panel or
[ ] button on the remote control.
Image being input to the [ / ] port：
[ ] button on the operating panel or
[ ] button on the remote control.
Image stored in an SD card/USB ash drive:：
[ ] button on the operating panel or
[ ] button on the remote control.
• When using a computer with an external output mode, set the computer to the external
output mode after pressing the [ ] button on the operating panel or the [ ] button
on the remote control.
• When the [ ] button on the operating panel or the [ ] button on the remote control
is pressed, the image being input to the [ ] port will only be output from the
[ ] port and the image being input to the [ ] port will only be output from the
[ ] port.
Note

Pausing the image
Press the [ ] button on the operating panel or the [ ] button on the remote
control to pause the camera image. Press the button again to cancel the pause.
RC
-
VL