24
English
OPERATION
PROCEDURE
Presentation using printed materials, etc.
Note
• When connecting to other devices, be sure to turn OFF the power of all the devices.
■ Setting the main unit
Set the main unit as shown in the above figure, connect the main unit to the projector or the
PC monitor, and then turn the power switch of the main unit ON.
■ Adjusting the size
Place an object, adjust the position of the object with the zoom dial so that the objective
part fits the screen size.
P. 3 5
■ Adjusting the focus
Press the [AF] button to focus the camera on the object.
P. 3 6
■ Adjusting the brightness
Press the [BRIGHTNESS •
] and [BRIGHTNESS • ] buttons on the main unit to
adjust image brightness.
P. 3 9
■ Turning the illumination lamp ON/OFF
Move the illumination lamp switch to the left/right to turn it ON/OFF.
OPERATION PROCEDURE
Note
• For best results, we recommend LCD projectors over DLP projectors to be used with
TT-02s. A better image may be produced by selecting “Graphics” mode with DLP
projector.
4
To Next Page
Loading...
Need help?
General
