ELNA 8300 - Adjusting Height of Embroidery Foot P; Setting Embroidery Foot P Height

22
Model 8300
Adjusting Height of Embroidery Foot P
Attach the Foot (P), and the space between the needle plate and the bottom surface of the
Foot (P) should be 1.0 to 1.6 mm, when the needle bar is at its lowest position.
1. Remove the face plate and top cover unit.
(See page 3)
2. Remove the face plate unit. (See page 3)
3. Lower the Needle and lower the presser foot lifter.
4. Insert the 1.2 mm Feeler gauge between
the Embroidery Foot (P) and the Needle plate .
5. While pressing the Presser bar actuator down
against the upper shaft cam, loosen the Screw
and push it down in the direction of arrow, then
tighten Screw again.
6. Reattach the face plate and top cover.
A
B
C
D
E
F
E
F
C
B
A
D