ELNA 9900 - Replacing the Moving Head (2)

22
elna 9900
Replacing the Moving Head (1)
To remove:
1. Remove the spool stand, static head cover
(right), right cover and left cover.
2. Disconnect the connectors. Remove the
setscrew of the cord clamp.
3. Remove either the left or right side of stopper
screw on the rail shaft.
4. Turn the idler gear to move the moving head to
the end of the rail shaft with the stopper screw
removed.
Support the moving head securely while remov-
ing the moving head so as not to fall.
To attach:
5. Attach the moving head. Tighten the stopper
screw.
Setscrew
Connector
Connector
Connector
Idler gear
Stopper screw Rail shaft
Cord clamp