ELNA 9900 - Adjusting the Needle Height

elna 9900
24
Adjusting the Needle Drop Position (Back or Forth)
1. Set the moving head to needle bar No. 3 (see
pages 26 and 39 of the instruction book).
Push the needle bar No. 3 down to engage the
needle bar clutch.
2. Turn the handwheel until the needle goes down
into the needle hole.
Loosen the 2 setscrews. Adjust the needle drop
position adjusting plate. Center the needle drop
position in the needle hole.
3. Adjust the hook timing (see page 34).
Setscrews
Needle drop position adjusting plate
Needle
Needle hole