26
elna 9900
Replacing the Needle Bar, Needle Spring and Cushion
1. Remove the presser foot (see pages 16 and
17).
2. Loosen the needle bar holder screw.
3. Pull the needle bar up and out of the frame.
To remove the parts on the needle bar, pull the
needle bar as far as the desired part can be
removed.
4. Insert the needle bar down into the frame and
put the parts on the needle bar as it goes.
5. Attach the presser foot.
6. Adjust the needle height (see page 25).
7. Adjust the presser bar height (see pages 16
and 17).
Needle bar
Needle bar spring
Needle bar holder
Spring base
Presser foot
spring (lower)
Presser foot block
Stop felt
Presser foot
holder
Presser foot
return spring
Washer
Needle bar
holder screw
To Next Page
