: Packing
Before packing, the analyzer and furnace must be wrapped in plastic foil, to protect it from
moisture and dust, and then to be placed in a wooden case. The wrapped analyzer should be
surrounded by a layer of foam (chips) of at least 10cm, in order to avoid any damage due
through transportation.
Especially the foam where the analyzer is placed on, is very important. It should neither be too
hard nor too soft. When the foam is too soft, the analyzer will practically touch the wood. Fix the
foam on the bottom of the wooden case by gluing.
The analyzer and the furnace should be wrapped in plastic foil, especially when you use chips
or any other kind of material in small pieces. The glass tubes must be empty.
In case of transportation by vessel, use a seaworthy crate.
Packing is done as follows:
To Next Page
Loading...
Need help?
General
