ELTRA CS-2000 - Dust Trap Cleaning-Resistance Furnace

Maintenance
68
Fig.
41
: Dust trap: outer and inner o-rings
6.8.2 Dust trap cleaning-Resistance furnace
Fig.
42
: Dust trap-Resistance furnace
• Remove the two screws (1).
• Remove the cover (2) using a screw driver if necessary.
• Remove the dust from the inside of the dust trap (4) using the brush (5).
• Do the assembling in reverse order.
Remark
The two screws (1) should be properly tighten to make sure that the system is sealed