4 Installation
4.1 Setting check up
Device falling down
Incorrect erection or inadequate working space
– Due to its weight, the device can cause injuries if it falls down.
• Only operate the device on a sufficiently large, strong, non-slip and
stable working area.
• Ensure that all feet of the device are standing securely.
Fire hazard / Risk of burns
Hot parts (crucibles, reagents,...) can fall down
Ignition of tables, floors, or any other surface the hot part falls on
Ignition of clothes and any other material
• Set up the analyser in a flame retardant environment. Pay special
attention to the table, the floor and any other surface being in the near
of the analyzer
• Always wear suitable clothing
• Keep the work environment clear of all materials that could catch fire
Installation of the machine
– It must be possible to disconnet the machine from the mains at any time.
• Install the machine such that the connection for the mains cable is
easily accessible.
High temperature / Burning of the skin
Hot combustion tube
• When the analyzer (HTF, resistance furnace) is switched on again after
switching off, the adjusted set point is driven immediately. Please
check this!
The analyzer weighs about 110 kg and the resistance furnace 36 kg so that they should be
placed on a suitably stable surface. The balance should be placed in a position so that it is free
of vibration.
The balance can be placed in any position, although positioning it to the right of the analyzer
has proved to be best suited.
The balance can of course also be placed on a weighing table next to the analyzer.
To Next Page
Loading...
