Workshop manual
25
Tensioning pulley (g) and idler pulley are installed on the
middle V-belt cover.
Slightly release the hexagon head screw (i) on the
tensioning pulley (g) until you can remove the V-belt (h).
Replacing toothed belt 125 cm
Disassemble the mowing implement. Remove the
V-belt.
Slightly release the hexagon head screws (a) and (b)
underneath the mounting plate (c) until the tensioning
rocker (d) can be moved.
Release the locknut (f) to loosen the adjusting screw (g)
of the tensioning rocker (e).
Release the hexagon head screw (g) and remove it
together with spring washer (h) and washer (i).
Remove the V-belt pulley (j) and (k).
To Next Page
Loading...
