EMC Connectrix B Series

108
EMC Connectrix B Series v6.2 ED-DCX-4S-B Hardware Reference Manual
Removal and Replacement Procedures (RRPs)
Figure 22 RRP: Core switch blade (CR4S-8)
Replacing a core switch blade (CR4S-8)
Note: Follow ESD precautions (“ESD precautions”).
1. Open the ejector handles to approximately 45 degrees; then,
orient the CR blade so that the handles are toward you and the
flat metal side is on the bottom.
2. Align the flat metal side of the core switch blade inside the left
and right blade guides in the slot; then, slide the core switch blade
into the slot until it is firmly seated.
3. Tighten the thumb screw inside each handle using the Phillips
screwdriver.