Emerson iPro - I;O Configuration; Analog Inputs

I/O Configuration Using the Visograph • 45
14.4. I/O Configuration
14.4.1. Analog Inputs
From the Main Menu select T2 to navigate to System Configuration and then T2 again to enter I/O Configuration.
Select T3 for iPro AI Configuration, T5 for XEV20_Config, T6 for Expansion 1 (IPX1_Config) AI Configuration or T7 for Expansion 2 
(IPC2_Config) AI Configuration.
Example of iPro AI Configuration, press T3 for iPro AI_Config. The iPro analog input selections are shown below. I/O can be set by
using T3/T5 keys to navigate and T4 to edit and save.
Pressing T7 advances to the next page where sensor offsets are shown by AI01O-AI10O, an offset for the connected sensor can be set
up here.
Figure 14-7 - I/O Configuration
Figure 14-8 - AI Configuration